Home Blog Industry knowledge Car Dome Instruction Manual

Car Dome Instruction Manual

30.07.2020

Car Dome Instruction Manual

一、Our Car Dome Features:

① Completely isolates your vehicle from any damages

② Designed for indoor use

③ Blower: one 10W 12V air Fan, for continuously filtered airflow. 

④ Takes 5-10 minutes to setup and inflate.

二、Before Setting-Up it: 

① While you can set-up on dirt or gravel, be sure there are no sharp rocks that could wear through the floor over time.

② Make sure there are no holes in the set-up surface with edges that could wear through the floor.

③ Some owners concerned with coarse surfaces put an additional tarp on the ground for added protection.

④ If the set-up surface has really large or coarse gravel we suggest a placing a plank underneath the zipper where the tires track. This avoids grinding the zipper into the gravel, thereby avoiding subsequent damage to the zipper.

 

三、How to use our car dome

Step 1- Drive onto the base sheet.

Step 2- Cover vehicle with top half, and zip around the base.

Step 3-Plug in the power, and the fans will inflatable in 5-10 minutes.

 

四、Maintenance Tips

① Clean the Air fan filters every few months (and more frequently in dusty environments) with soap. Rinse thoroughly and allow to air dry.

② Use a car duster to dust the top and sides off.

③ Wash with mild soapy water.

④ Periodically check fans and power adapters to ensure proper operation.

Drive in Instruction Manual

 一、Drive In Model Features:

① This Drive In model uses FRP tube which provides vehicle access to the rear and excellent access along both sides of the vehicle. 

② The Drive In Model has been designed for indoor use.

③ The Drive in model is ideal for the more frequent user and also the enthusiast who needs access for detailing or maintenance.

④ Three opening sides provide all-round access into the Drive In environment, providing enough space to fully open all the car doors. 

⑤ The Drive In Model use 12V 10W air fan for the interior airflow circulation.

 

二、Before Setting-Up it: 

① While you can set-up on dirt or gravel, be sure there are no sharp rocks that could wear through the floor over time.

② Make sure there are no holes in the set-up surface with edges that could wear through the floor.

③ Some owners concerned with coarse surfaces put an additional tarp on the ground for added protection.

④ If the set-up surface has really large or coarse gravel we suggest a placing a plank underneath the zipper where the tires track. This avoids grinding the zipper into the gravel, thereby avoiding subsequent damage to the zipper.

 

三、How to use our Drive in

Step 1- Unpack the car cover and spread it on the base.

Step 2- Put all the FRR tubes inside the car cover.

Step 3- zip shut the car cover.

Step 4- Plug in the power and inflate the car cover.

Step 5- Get into car cover and set up the tubes according to the installation drawing(Please see the installation drawing on the other paper).

Step 6- Open the zip of front panel.

Step 7- Drive the vehicle into the car cover.

 

四、Maintenance Tips

① Clean the Air fan filters every few months (and more frequently in dusty environments) with soap. Rinse thoroughly and allow to air dry.

② Use a car duster to dust the top and sides off.

③ Wash with mild soapy water.

④ Periodically check fans and power adapters to ensure proper operation.